00 Gundam Seven Sword/G

Notes

• Contains the 00 Gundam (runners A–U, steps 1–13), the seven swords: GN Buster Sword II, GN Sword II Short and Long, 2 GN Katars, GN Sword II Blaster, 2 beam sabers (runners SA1–SH, steps 14–18, 20–24) and an Action Base (BA13, step 19).
• The 00 Gundam frame shares runners with the PG 00 Raiser: shield, old GN Sword II and 0 Raiser pieces on shared runners are marked ✕ and not used (A-1, A-2, A-13, B-3–6, C-7, C-8, F-9, G-18, G-19, H-1, H-7, H-8, H-9, H-26, I-6, Q-3, Q-9–13, T-1, BA13-B-1, -18, -19).
• Runners supplied twice: B, F, H, I, M, P, Q, T, U, SF, SH. The second U runner marks 2, 3, 6, 7, 8, 9, 10, 14, 15, 17 with ✕; the second SH runner marks 2 with ✕.
• Some numbers cover 2–3 pieces on one runner: A-6, 7, 8 (L/R), 10, 11; E-22, 24; F-1, 20; J-1, 10; L-19 (3 pieces); M-1, 2, 3; O-10; P-11, 23, 24; SB-9; SF-2; SG1-1; U-30. SA2 only has 5–13, SC2 only 16–27, SG2 only 4–6.
• Not counted: 2 green LED units and 2 GN Drive units (included pre-built; shown under LED parts), springs, screws, hex bolts/nuts, wire and batteries (LR41 ×4, CR2032 ×2 sold separately). J1-1 (LED battery cover) is counted as a normal part.
• O-9 is a jig reused for the six arm GN condensers (step 8-0); cut one. The hand frames and fingers (runner N) are assembled on the runner before cutting.
• Hologram sheet pieces are listed by the printed letter (Holo A–K on sheet 1, Holo L–R on sheet 2). Sticker A by number; sticker B is a whole sheet under each sole. Head stickers 1–4 are optional, skip them when using the LED.
• Steps 20–25 cover weapon modes and gimmicks: only new parts are listed (sword-gripping hands, katar mounts, beam sabers T-2).